1/9/2023 0 Comments Tera term macro![]() Your current meter’s positive and negative terminals should be connected as shown in the picture below. USB-CDC keeps the USB port alive, and USB is not a low power interface. It allows device to go to its lowest power states. Note: To measure lowest possible power, it is recommended to use UART to issue commands. To do this you will perform the following:Ĭonnect the EVK’s UART port to your PC using the included USB A to USB Micro cable.Ĭonnect the EVK to your current meter through its “MEASUREMENT” port. Connecting the RS9116 EVK to your PC to the perform current measurements # Once connected put the module in low power (WLAN standby associated) state. This application demonstrates the procedure to connect RS9116W to an Access Point. WLAN Low Power Standby Associated Station Tera Term Script #
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |